by Doug Rucker Doug Rucker

COMMERCIAL PRESSURE WASHING

There are several unique challenges that arise with COMMERCIAL PRESSURE WASHING projects.  These challenges are generally set apart from an average residential home.  However, some of the challenges can be found on larger mansions and larger residential properties.  These COMMERCIAL PRESSURE WASHING tips and tricks will help better prepare you for cleaning commercial properties.

COMMERCIAL PROPERTY PROTECTION

Any time you clean close to grass, plants, or landscaping, it is very important to PRE WET the surface and the ground below.  So as you pre wet the surface with 100% water, you also pre wet the grass, plants and landscaping.  After pre wetting, you apply your cleaning solution, which is usually about a 40%-50% mix.  Do not flood coat with this solution, but rather provide a nice medium coat of mix.  When we rinse the building, that water will also help dilute the mix and protect the plants.  You will then spend even more time watering the grass to ensure that solution does not damage any plant life.  The area will most likely be pretty soggy when you walk across it.  Special attention should be paid to any shrubbery or trees that are close to the building.  Previous amounts of rain water will also affect the amount of water needed for pre wetting to prevent damage to plant life.  If sprinkler systems are present, this would also be an important factor for commercial pressure washingGet even more property protection tips here.

PREVIOUS CLEANING SERVICE

Are there any signs of previous exterior cleaning?  In this particular case, we notice the use of a wand.  While sections closer to the ground are clean, how high they were able to reach was limited.  It’s important to document this in the event that damage was caused previously that you are not responsible for.  Commercial Pressure Washing surface damage is fairly common so be on the look out for this.

COMMERCIAL CLEANING SOFT WASH METHOD

Our cleaning starts with the KINGSLINGER soft wash system.  We apply a 50% mix after pre wetting in a cross way pattern.  It’s important to apply a nice even coat to avoid dry spots on the surface.  Depending on the severity of the stains, it may take two or three coats to reach maximum clean.  Using a soft wash strategy is the best approach for commercial pressure washing jobs.

COMMERCIAL CLEANING SURFACE IMPERFECTIONS

When evaluating commercial pressure washing projects, consider whether the property has been well maintained.  If that is not the case, there may be damage to the surface which exists under some stains.  In fact, some organic and biological growth may have penetrated the paint, exposing the surface.  So it’s important to document and communicate this to the customer.  This way, you are not held responsible for preexisting damage which might show after cleaning.  Again, this is why the soft wash method is critical for cases like this.

Commercial Pressure Washing